Additional Images
KSC-SW10
Passive radiator powered subwoofer system
DISCONTINUED MODEL
Key Features
| 150W peak power |
| Passive radiator powered subwoofer system |
| 3 points attenuator |
| Dual voice coil |
| RCA & speaker level input |
| Aluminimum Die-cast Back-frame |
| Variable cut-off frequency (50-120Hz) |
Speaker Features
| Speaker System | Active subwoofer system with Passive radiator |
| Speaker Type | Subwoofer |
| Peak Input Power | 150W |
| Speaker Size | 120 x 180mm |
| Passive radiator system | Yes |
| Dual Voice Coil System | Yes |
| Wired remote included | Yes |
| Cross-over Network | Built-in amplifier |
| Amplifier Included | Built-in |
Amplifier Features
| Maximum power output | 150W |
| Low-pass Filter | Yes |
| Phase inverter 0°(Normal) / 180°(Reverse) | Yes |
| Power Indicator | Yes |
| Line in | 1 RCA, 1 mini-jack |
| Speaker level Input | Yes |
| Chassis | Aluminum Die-cast Back-frame |
| Die-Cast Aluminium Heat Sink | Yes |
| Yes | |
| DC cable Supplied | Yes |
Speaker/woofer Specifications
| Peak Input Power | 150W |
| Woofer Cone material | Paper cone |
| Speaker Basket | Steel |
| Aluminum Die-cast back-frame | |
| Speaker Surround | Rubber |
| Sensitivity | 91dB/W/m |
| Frequency Response | 35Hz ~ 120Hz |
| Subwoofer Impedance | 2Ω x 2 |
| Dimensions (W x H x D) | 369 x 94 x 224mm |
| Gross Weight | 3400gr |
Amplifier-Specifications
| Maximum power output (4Ω) | 150W x 1 |
| Low-pass Filter | 50~120Hz |
| Signal to Noise Ratio | 85dB |
| Frequency response (+0dB, -3dB) | 35Hz ~ 120Hz |
| Operating voltage | 10.5V (16V ～ 14.4V allowable) |
| Maximum current consumption | 8A |
Accessories
| Remote control | wired remote |
| Electro tap: 4 pieces | |
| RCA cable | |
| DC cord | 100 cm |
| Screws (Parker-type) | Ø 5 x 16mm, 6 pieces |
| Screws (M-type) | M4 x 6mm, 8 pieces |
| Installation brackets | 1 pieces |
| Adhesive tape pad | 1 piece(s) |
| Bracket A | 2 pieces |
| Bracket B | 2 pieces |